Hi all
Can anybody help me, I am trying to find a template for the drill holes on the gas filler locking mechanism as my car must have had a repair in the past and no holes were drilled for the locking pin or the screw's.
Any assistance would be gratefully appreciated.

I do not know of any where that kind of detail might be. Best option might be to "borrow" a similar car from a friend or junkyard and just measure and photo the area you need details about.

Quote
Bob in Everett
I do not know of any where that kind of detail might be. Best option might be to "borrow" a similar car from a friend or junkyard and just measure and photo the area you need details about.

That sounds like a good plan

Rick,

Don't you have one in the driveway(sort of covered with weeds)?

Surely a quick trip wit a tape measure couldn't hurt

I know; I know...what measurements do I take

I hope the reason you are doing this is not because some of the go juice was liberated from your tank...

Bob in Lake Havasu

Here's a photo for ya.

Quote
Ferdinand
Here's a photo for ya.

I'm thinking that the lock mechanism mounting holes will be behind the liner inside. That panel is difficult to remove or I would just take a picture and post it too.

Bob in Lake Havasu